Bentel Omnia 4 Dokumentacja Pobierz pdf (Strona 46)

Times

The Entry time, Exit time and Arming delay time of each partition can be

programmed separately in this page.

The Control panel can manage up to 4 partitions.

The partition parameters are as follows.

no. This is the non-modifiable partition identifier number (1 ...4) which will be

used instead of the partition description (refer to following paragraph).

Description This is a modifiable field for the partition name (maximum 16 characters).

The name will allow proper identification of the partition and will be used in

other parts of the program, and in the Event Buffer.

Entry time This setting determines the delay that will be generated by violation of a

zone with Entry Time programming. Entry Time will be signalled by:

Ø activation of the corresponding partition outputs (with Entry Time program-

ming);

Ø an audible signal (fast beep) on the enabled keypads of the partition of the

violated zone.

Exit time Violation of an armed zone with Exit Time programming will not generate

an alarm during the programmed delay. The delay will start when the parti-

tion is armed, and will be signalled by:

Ø activation of the corresponding outputs (with Exit time programming);

Ø an audible signal (slow beep) on the enabled keypads of the partition of

the violated zone.

Arming delay

time

The Arming delay time must be programmed in minutes. An output must

be programmed for the Arming delay signal (in order to signal the elaps-

ing Arming delay time).

Example

The control panel will start signalling at 17.30 and will continue until 17.45

if:

----the Timer is programmed to arm the partition at 17.45

----the partition is programmed with a 15 minute Arming delay time

----an output, assigned to the partition, is programmed with Arming delay

time.

Auto arming can be delayed by 30 minute overtime requests ----valid until

24.00 (refer to "Timer" paragraph).

Arming delay: 0 through 240 minutes with steps of 1 minute

0 minutes = No Arming delay

Patrol Time This setting determines the time between disarming of partitions ----by a

Patrol Code PIN, and rearming. Patrol Time: 0 through 99 minutes. The

programmed time will be the same for all partitions.

46 Security System Control Panels Omnia8/4

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 111 112

Brak uwag

Bentel Omnia 4 Dokumentacja Strona 46